Peugeot 208 Forums banner
1 - 2 of 2 Posts

·
Registered
Joined
·
32 Posts
Discussion Starter · #1 ·
Hey all,

I have a 1.2 2014 208. I need to replace the brake reservoir but cannot seem to figure out how to release the fluid pipe? There is a grey portion towards the end of the pipe but it goes all the way round from what I see, so I'm not sure how you loosen / release it? (See pics of the fittings)

Any help would be much appreciated.



Sent from my moto g(8) plus using Tapatalk
 

·
Registered
Joined
·
32 Posts
Discussion Starter · #2 ·
Hey all,

I have a 1.2 2014 208. I need to replace the brake reservoir but cannot seem to figure out how to release the fluid pipe? There is a grey portion towards the end of the pipe but it goes all the way round from what I see, so I'm not sure how you loosen / release it? (See pics of the fittings)

Any help would be much appreciated.



Sent from my moto g(8) plus using Tapatalk
For anyone wanting to know, it is a pull it off job. It is on tight so it's not easy, I recommend using a trim pry tool (the metal one that look like a fork, not the cheaponorsnge eBay ones). This will allow the pipe to slot into the notch on the trim pry bar tool and then you can pull it down by wriggling the pry tool

Sent from my moto g(8) plus using Tapatalk
 
1 - 2 of 2 Posts
Top